IoT Systems

Systems

Ubimote

Ubimote is a System on Chip based Low Power and Medium range RF communication module compliant to IEEE802.15.4 supporting a maximum transmitting power of +7 dBm. Ubimote supports application development platforms like Contiki OS, Zigbee and custom stacks.

Features:

  • Highly integrated System on Chip with ARM Cortex M3 microcontroller with
    • Up to 32-MHz Clock Speed
    • Up to 32KB of RAM (16KB With Retention in All Power Modes)
    • Two timers (16/32 bit)
    • 512KB of In-System Programmable Flash
    • Supports On-Chip Over-the-Air Upgrade (OTA)
    • Battery Monitor and Temperature Sensor
    • 12-Bit ADC With 2 Channels and Configurable Resolution
    • USB 2.0 Full-Speed Device (12 Mbps)
    • Four Universal Serial Communication Interfaces (USCIs)- SPI, UART, I2C
  • External Flash Memory
    • 8Mb Flash memory, Up to 75 MHz clock frequency
    • SPI Interface , Write Protection, Deep Power Down Mode
  • RF subsystem
    • ISM Band RF Transceiver with RF frequency range 2394-2507 MHz (2.4 GHz)
    • IEEE 802.15.4 compliant DSSS baseband modem with 250 kbps data rate
    • Low Power (RX -97dBm @ 20 mA, TX 0 dBm @ 24 mA)
    • Ultra low power down mode (<1.3μA)
    • Good receiver sensitivity (-100 dBm), Adjacent channel rejection: 44 dB and Alternate channel rejection: 52 dB
  • Security sub system
    • Future Proof AES-128/256, SHA2 Hardware Encryption Engine
    • Optional - ECC-128/256, RSA Hardware Acceleration Engine for Secure Key Exchange
  • Expansion headers for connecting Ubi-Sense, Ubi-DAC and external sensors
  • Intelligent power system with rechargeable lithium polymer battery and solar energy harvesting

BLE mote

BLE mote is a system on chip based device for Bluetooth Low Energy based applications. This mote is compliant to the Bluetooth 4.0 standards with Low Energy Profile support.

Features:

  • Highly integrated System on Chip with ARM Cortex M0 microcontroller with
    • 32 kB RAM, 256 kB flash Memory
    • Supports various Serial Communication Interfaces like SPI, UART, I2C, Timers, ADC
    • CPU independent Programmable Peripheral Interconnect (PPI)
    • Real Timer Counter (RTC)
    • Watchdog Timer (WDT)
  • External Flash Memory
    • 8Mb Flash memory with Write Protection and Deep Power Down Mode
  • RF subsystem
    • 2.4 GHz ISM Band RF Transceiver compliant to Bluetooth 4.0 LE standards
    • 250 kbps, 1 Mbps, 2 Mbps supported data rates
    • GFSK Modulation
    • Programmable Transmit power of +4 dBm to -20 dBm (in 4 dB steps)
    • High Receiver Sensitivity (-93dBm in BLE)–Low Power (Peak Rx -93dBm @ 13 mA, Peak Tx 0dBm @ 10.5 mA)
    • Ultra low power multiple down modes
  • Security sub system
    • AES Hardware Encryption Engine (AES Electronic Codebook Mode Encryption, AES CCM Mode Encryption), Accelerated Address Resolver, Random Number Generator
  • Expansion headers for connecting Ubi-Sense, Ubi-DAC and External Sensors
  • Intelligent power system with rechargeable lithium polymer battery

Wi-Fi mote

It is based on Wi-Fi Certified wireless MCU with built-in Wi-Fi protocol stack targeted for Internet of Things (IoT). The maximum RF transmitting power is up to +18dBm. For the application development Free-RTOS and TI-RTOS can be easily integrated.

Features:

  • High-performance ARM Cortex-M4 MCU with
    • Wi-Fi Network Processor with 802.11 b/g/n Radio, Baseband, MAC, Wi-Fi driver
    • Power-Management Subsystems with integrated DC-DC converters
    • RAM of 256KB
    • External Serial Flash Boot loader
    • 2 General-Purpose Timers with 16-bit PWM mode
    • 2 Channel 12-bit ADCs
    • Clock sources with 40MHz and 32.768kHz
    • Four Universal Serial Communication Interfaces (USCIs)- SPI, UART, I2C
    • Provides an application throughput of maximum 16Mbps
    • Supports Station, Access Point, and Wi-Fi Direct modes
  • External Flash Memory
    • 8Mb Flash memory, Up to 75 MHz clock frequency
    • SPI Interface , Write Protection, Deep Power Down Mode
  • Wi-Fi network processor subsystem
    • Dedicated ARM MCU completely offload the host MCU
    • Robust 802.11 b/g/n radio, baseband, and MAC
    • Powerful crypto engine for a fast, secure WLAN and Internet connections with 256-bit encryption.
    • Supports WPA2 personal & enterprise security and WPS 2.0.
    • Embedded IPv4 TCP/IP stack
  • Security sub system
    • Hardware Crypto Engine for Advanced Fast Security including AES, DES, and 3DES, SHA2 and MD5, CRC and Checksum
  • Expansion headers for connecting UbiSense, UbiDAQ and any other external sensors
  • Intelligent power system with rechargeable lithium polymer battery

WINGZ (Wireless IP Network Gateway for Zigbee)

Features

  • Processor
    • ARM Cortex-A9 application Processor(Single/dual/quad)
    • CPU clock speed up to 1GHz
    • 2D and 3D graphics co-processors
  • Power Management
    • Advanced power management system with module wise power control
    • Flexible power input with dynamic source switching
    • Integrated Li-Ion battery management with solar energy harvesting capability
    • Dynamic Voltage and Frequency Scaling
  • Memory
    • 1 GB/2 GB DDR3 SDRAM
    • 4GB/8GB onboard eMMC flash memory
    • External Micro-SD card support (up to 32GB)
    • 4Mbytes Serial Flash
  • Connectivity
    • Onboard Gigabit Ethernet (RJ45) ports
    • Two USB 2.0 host type A ports
    • One USB-OTG Port
    • One High speed CAN (DB-9) port
    • Supports various Serial Communication protocols like SPI, I2C, UART
  • Display
    • Onboard 7” LCD with capacitive touch panel
    • High Definition Video Output through HDMI Port
  • Camera
    • Supports CMOS Camera (Optional 5MP Raspberry Pi camera)
    • Supports various USB based web cameras
  • Audio
    • High quality Stereo audio codec
    • Mobile phone compatible 3.5mm audio port for Audio In/Out
  • Wireless Connectivity
    • High Range IEEE802.15.4 (ZigBee/6LoWPAN) Transceiver (upto 22dBm Tx power)
    • Dual Mode Bluetooth4.0 Connectivity (with BLE profile)
    • IEEE802.11b/g/n compliant WLAN (Wi-Fi) Modem
    • 3G Cellular Network Connectivity (GSM/GPRS/EDGE/HSPA+)
    • GPS/NGSS Positioning system
  • Onboard Sensors
    • Temperature and Relative Humidity Sensor
    • Digital Ambient Light Sensor
    • 3-Axis Digital Accelerometer
  • Debug Interface
    • JTAG connector (20-pin) for Main Processor
    • SWD connector for BLE SoC
  • OS Support
    • Linux
    • Android
    • Windows*
  • Application
    • Gateway device between the WPAN and IP network
    • Coordinator device for the WPAN networks
    • Indoor/Outdoor deployment of Internet of Things solutions
    • Single board computer
    • Unified control and monitoring console for various wireless networks

Add-on cards

Ubi-Sense

Ubi-Sense is a generic sensor board having the following listed sensors.

Sensors

    • Temperature and Relative Humidity
    • Light Intensity
    • Barometric Pressure
    • Proximity sensing
    • Buzzer

All the sensors can be interfaced with microcontroller via I2C bus. It contains additional I2C connector for connecting external I2c compliant sensors to the communications modules. Ubi-Sense mates with all three Ubimote, BLE mote and Wi-Fi mote through their expansion connector and sensor interface libraries are available for all the communication modules

Ubi-DAQ

Ubi-DAQ is a data acquisition card which contains peripherals like ADC, RTC, IO expander and Relay. All the peripherals can be interfaced with microcontroller via I2C bus. Each peripheral on Ubi-DAQ has unique I2C address. This card provides additional analog and digital IO capability to the communications modules for connecting more number of sensors

Features

    • Single Ended and Differential 8 Analog channels
    • 8 Digital channels
    • RTC support
    • High drive capability Relays

Optional/ Additional systems

C-Mote

The C-Mote is a Wireless communication module designed with a robust RF front end and highly flexible power management system.

Features

    • IEEE 802.15.4 compliant WSN platform
    • Two-chip solution based on the popular CC2520 transceiver along with ultra low power MSP430 MCU
    • High range with +5dBm output power and Compliant to IEEE 802.15.4
    • Over The Air Programming
    • Dynamic Voltage and Frequency Scaling for effective power management
    • Application development using TinyOS, Contiki-OS and Custom stacks
    • IP65 certified enclosure
    • Smart Power Management with Solar Energy Harvesting
    • Usage
    • Can be used as coordinator/ router or end device
    • Indoor/outdoor deployment as sensor node.

Ubimote-HR

This mote is a high range variant of Ubimote supporting a maximum RF trasmit power of +20 dBm.

Wireless accelerometer and wireless T& RH sensor

These two modules are dedicated sensor embedded Zigbee modules of tiny size and operate with a small battery as power source. These modules come with debug connector and embedded sensor on a communication module in a tiny size.